Net_rim_crypto

Net_rim_crypto

Fix for: LA Noire: The Launcher cannot query DirectX. Please update DirectX by installing the latest redistribution. Howto: Enable debugview for RMS 1. As you have net_rim_crypto already noticed ESXi has a very limited console interface.

You should now see a warning from the VMWare technical support team. Login as root and enter your root password. You may have to hit i to enter insert mode. You have now sucessfully enabled ssh.

For those of you not familiar with SCP, the protocol basically acts like a secure FTP client allowing for file trasfers using a encrypted tunnel. Fix for: LA Noire: The Launcher cannot query DirectX. Please update DirectX by installing the latest redistribution. Howto: Enable debugview for RMS 1.

If you do not wish to setup the switch yourself or are looking for expert help, consider hiring Blackhawk Consulting to assist you with your switch and network needs. They allow you to logically divide up your switched network to improve network speed, security, and reliability. If you have other Cisco equipment in your network, such as Cisco wireless access points or Cisco PIX firewalls, setting up your switch correctly will give you a big return as all the Cisco equipment is VLAN aware. Before you begin defining VLANs on your network, first decide what the purpose is for each VLAN.

One in New York, and One in California. In our example, we will set up each VLAN with the above ip configuration. The ip configuration tells the switch what network segments are where which will allow your switch to do routing between VLANs. You have now successfully set-up the 4 VLANs. XX where XX is the vlan number you want to remove.

Now that we have the basic VLAN infrastructure in place we need to assign gateways for each VLAN. The gateways will inform the switch what network segments each VLAN represents. In this case, we see that NY uses 10. In order to keep things simple, we will assume that the gateways are 10. We now have now told the switch what address range is used in each VLAN.

At this point we have not created the VLANs and assigned address ranges to them. Step 3: Assign ports to VLANs. The next step is to assign the physical ports on your switch to specific VLANs. The result of the above commands is that each physical port on the switch has now been assigned to a specific VLAN. 1-4 are now assigned to vlans 2-5. The final step is to ensure VLAN routing is turned on. First test: See if you can ping your client from the switch using the ping command.